Target holder jaw MT102

Our target holder jaws can be adapted to all your target holders to match your entire targeting system.


Our target-holder jaws are designed for long-lasting, efficient use of your equipment. They are compatible with all our target holders for ease of installation, and can withstand up to 20 impacts without risk of return (impacts spread over all surfaces and rods, excluding fixing points).


Assembly :

  • Normal vertical
  • Inverted vertical (head down)


Technical data :

  • Rod plus clamp for supports from 5mm to 55 mm (any material, usually extruded polystyrene)
  • Tightening with butterfly screws
  • Material: Aluminium + 6 mm steel screws


Height: custom-made from 30 to 120 cm
Weight: 0.6 to 1 Kg depending on stem length
Width: 50cm for 40 to 60cm wide supports

These products may also be of interest to you

Target holder jaw MT102

Z-shot E-lite accessories

Projector 360-7


This site is registered on as a development site.